Post by Borderman on 11.06.20 at 22:30:28
I hope I have that right ... see picture attached ... not sure what you mean about the slide cutout?
|
Manfred's TR1. Discussion Boards
https://www.tr1.de/cgi-bin/yabb2/YaBB.pl TR1 Discussion Boards >> Help me! I'm lost with my TR1! >> Carburetor diaphragm replacement https://www.tr1.de/cgi-bin/yabb2/YaBB.pl?num=1591802338 Message started by Borderman on 10.06.20 at 17:18:58 |
|
Title: Carburetor diaphragm replacement Post by Borderman on 10.06.20 at 17:18:58
Hi All, Need some help/advice... I bought a set of replacement diaphragms for my 1981 TR1 but when I removed the old diaphragms I did not mark the slide in relation to the locator tab on the top of the carb. There are two holes in the slide that I assume must sit in a specific location (or maybe not) Hope this makes sense ... is there anyone who has completed this on another bike who can advise? |
|
Title: Re: Carburetor diaphragm replacement Post by nanno on 11.06.20 at 09:38:29
The slide cutout goes towards the airfilter, i.e. away from the engine.
|
|
Title: Re: Carburetor diaphragm replacement Post by Borderman on 11.06.20 at 21:28:22
Thanks ... I got some info off the net ... shows similar carbs and advises that the 2 holes on the bottom of the slide should be towards the engine side :thumb:
|
|
Title: Re: Carburetor diaphragm replacement Post by Borderman on 11.06.20 at 22:30:28
I hope I have that right ... see picture attached ... not sure what you mean about the slide cutout?
|
|
Title: Re: Carburetor diaphragm replacement Post by hornschorsch on 12.06.20 at 13:12:24
Some carbs have slides which are beveled at the lower end but according to your photos this is not the case with the TR1.
|
|
Title: Re: Carburetor diaphragm replacement Post by Borderman on 12.06.20 at 13:21:59
Thanks .... appreciate the reply |