|
Manfred's TR1. Discussion Boards
https://www.tr1.de/cgi-bin/yabb2/YaBB.pl TR1 Discussion Boards >> General technical TR1 discussions >> Rear Shock https://www.tr1.de/cgi-bin/yabb2/YaBB.pl?num=1626634244 Message started by shalesy on 18.07.21 at 20:50:44 |
|
Title: Rear Shock Post by shalesy on 18.07.21 at 20:50:44
Anyone know where I can get the bottom bush pin - 93612-99168 - from or the dimensions of it? The bush I have found at CMSL. Thanks, John |
|
Title: Re: Rear Shock Post by Kiwimanx on 18.07.21 at 22:16:09
XV1000 5A8 rear shock lower bush pin M12 x 122. Just re-installing my repainted swing arm so was easy to get at. Hope this helps |
|
Title: Re: Rear Shock Post by shalesy on 18.07.21 at 22:31:18
Thanks for that Kiwi. Anything special about it? Hardened?
|
|
Title: Re: Rear Shock Post by nanno on 18.07.21 at 23:08:34
File-test didn't reveal a hardened pin at least not on my TR1(s)
|
|
Title: Re: Rear Shock Post by shalesy on 19.07.21 at 08:34:18
[smiley=beer_2.gif] Nanno
|
|
Title: Re: Rear Shock Post by nanno on 19.07.21 at 09:40:55
I also admit knocking one up from a bit of stainless bar just to see how it goes. But this has only done a hundred km or so.
|
|
Title: Re: Rear Shock Post by kdemery on 20.07.21 at 12:37:09
I too knocked one up from stainless. Mine has been on for thousands of miles with no sign of wear. Kevin |
|
Title: Re: Rear Shock Post by shalesy on 21.07.21 at 13:54:06
1m of stainless bar just arrived. :thumb: |
|
Title: Re: Rear Shock Post by shalesy on 12.10.21 at 13:28:37
Just by way of an update, the bottom bush, supplied by CMSL is NOT correct. The part number on the package was correct but it is for a smaller diameter pin. As the pin is a good "sliding fit" in the bottom bush, I returned it. |